產品特點：
1.機械互鎖設計，安全可靠：
2.插桿、拉桿尾部采用高頻退火處理，方便二次加工安裝孔；
3.此鎖膜組件不但具有控制開模順序功能，同時能控制合模順序。
4.設計簡潔，容易安裝，操作時具有高度的可靠性，經試驗和測試與Z171可以兩選一使用。
Features:
1.mechanical interlocking design,safe and reliable.
2.Insert bar,end of pull rod adopt high frequency annealing treatment,so that easy to second time processing installed holes.
3.This latch parts not only control opeing mold sequence,But also control closed open sequecnce.
4.Designed simple,easy to install.The height is adjustable when operating.Test proved that you can choose one from z171
安裝使用說明：
. 首先安裝主體，要求平行于分型面安裝；
. 安裝拉桿，將拉桿截制成所需要的長度，并加工螺孔，在合模狀態(tài)下鎖緊螺絲（注意：拉桿固定前必須保證模具處于wq合模狀態(tài)，并已xc拉桿與滾輪銷之間間隙，再鎖緊螺絲）；
.安裝插桿，將插桿截制成所需要的長度，并垂直于分型面安裝（注意保證幾套鎖模裝置的行程一致）；
. 每套模具至少使用兩套或兩套以上的鎖模機構并且對稱安裝，如未在模具上對稱安裝將可能導致單套鎖?？凼芰Γ芰Σ黄胶猓ú痪е?鎖?？蹟嗔?；
. 鎖?？哿慵榫芘浜?，請勿與其他自行加工的零件配合使用，由此帶來的異常將由貴司自行負責;
. 如模具需要維修改動，請先拆除鎖模裝置后再進行后續(xù)操作;
. 在安裝完畢后，請在合模機或注塑機上慢速進行開合模順序測試，以確保正確無誤。（不建議用吊機測試，因為吊機易不平衡）
Installation Guidelines:
. Please install the housing in parallel to the parting line first.
. Before install the control bar,please cut it to the necessary length ,form the bolt hole,Please tighten the screw when mold closed .(Please note:Make sure in a fully psition mold before fix the control bar,and eliminate the clearance between the control bar and locking roller).
. Pleace cut the latch bar to the necessary length,and installation in parallel to the parting line.
. Please install the latch lock symmetrically,otherwise,it would be fractured with the unbalanced force dueto only one side of locd set be forced,
. This latch locd is the precise standardized item,pplease do not apply together with other own customer machined parts.
. If mold need to maintain,please remove the latch locks first.
. After installed,carry out a functinal test,check whether the individual parts of the latch lock units moves soothly,the stroke is applicable.Recommend testing on matched Molds machine or lnjection machine,no Lifting Machine.
廣告
